Jehinten's latest activity
-
This can help, but raises the total strength of the support thus reciprocally dropping elastic dampening response. Support against load... -
Jehinten replied to the thread Finn eagle 254 wheel hub.I had the exact same issues with my Vermeer. Knock on wood, rebuilding the motor shaft and replacing the hub at the same time seems to...
-
Jehinten replied to the thread 3:1 pretension on porta wrap (?s).If more pull is often needed, a DWT can be setup as well, adding mechanical advantage in the canopy.
-
He knows how to sweat the line, and when possible I help from my end also.
-
Jehinten replied to the thread 3:1 pretension on porta wrap (?s).In the past I've used a handled ascender with either a carabiner or pulley below it. Luckily I never shredded a rope, same can be done...
-
Yeah.... at first I wanted to claim “freak accident” but in reality it was just an accident waiting to happen. Feel really really dumb...
-
Jehinten replied to the thread What Is Your Worst Accident?.The chance of this kind of thing happening has always bugged me. I won't bring a polesaw up without a sheath, then the sheath either...
-
Jehinten replied to the thread What Is Your Worst Accident?.Fell from about 15', not terrible compared to some stories but I hit a limb on my left side and bruised some ribs on the way down. It...
-
Jehinten replied to the thread WTB large saw.Stored properly with empty fuel and oil tanks, possibly. I've looked into them out of curiosity. Their website has a disclaimer...
-
Jehinten replied to the thread WTB large saw.Assuming your probably running a 32" bar, you could make it work for no more than the amount of trunk that you have. Its a bit extra...
-
Jehinten replied to the thread could have been worse, and more expensive.Assuming you mean that your wearing this sling like a chest harness, just leave it on throughout the climb. When I used a sling for...
-
Jehinten replied to the thread What’s Your SMALLER Equipment Setup?.Potentially, I just used what I had on hand.
-
Jehinten replied to the thread Rope Runner Critical Incident Report August 2020.I can understand the first half of this, but any system installed wrong will fail one way or another. At best it'll lock up, at worst it...
-
Jehinten replied to the thread Standing Pieces Up.Pretty new to crane work myself, even took my first brush picks yesterday. Before that its always been ground work and some trunk...
-
Jehinten replied to the thread Makita chainsaw review video.Its been working well, but due to job scopes not getting much use on the job. Its super handy around the shop though when needing to...
