Adjustable Chute for BC1800XL wanted...

Hey all, I have a Vermeer BC1800XL chipper and recently found out there is an adjustable chute for it. Does anyone have one available, perhaps from a shelled out machine or a wrecked machine? I have the fixed chute and it hits so high on our chip/boom truck that we have to point the deflector down so we can't fill the box unless we unhook the chipper each time and lower the tongue.

Vermeer wants a fortune for the new parts so looking for a used one... Thanks!
 
I'm not sure what you mean by the arm. Discharge chute/ tube?

Most chippers have a straight-to-downward deflector at the top-end of the chute. I've seen the deflector flipped, making it a straight-to-upward-deflector, fwiw.
 
I understand what you’re talking about. My old chipper is the same way where the discharge shoot doesn’t articulate before the deflector.
Honestly you might be better off copying bandits style, just get some weld on hinges, cut the shoot with a skinny wheel, weld on some 1/4” flat bar and some “ears”
Weld some mounts for a trailer jack…
Just a couple hundred bucks in materials and a weekend diy, or I bet a fab shop can do it for the delivery cost of a shipped used or new shoot.
 
I understand what you’re talking about. My old chipper is the same way where the discharge shoot doesn’t articulate before the deflector.
Honestly you might be better off copying bandits style, just get some weld on hinges, cut the shoot with a skinny wheel, weld on some 1/4” flat bar and some “ears”
Weld some mounts for a trailer jack…
Just a couple hundred bucks in materials and a weekend diy, or I bet a fab shop can do it for the delivery cost of a shipped used or new shoot.
I agree, modifying your existing chute may be the easiest and least expensive solution. And the Bandit style is very nice design, really easy to use and simple to maintain. It simply works.
 
Here is how I modified my old chipper chute. The adjustment here could have been faster, but it also had enough travel to open the chute if the 90° were to get clogged and its not something you'll change the angle of everyday.

This old chipper had torn the inner layer on the backside of the 90° which caused material to get stuck and clog, so I had the bend rebuilt here and narrowed the outfeed side by an inch to allow an overlap where it pivots
 

Attachments

  • Screenshot_20261108_055006_Photos.webp
    Screenshot_20261108_055006_Photos.webp
    177.3 KB · Views: 11
  • Screenshot_20261108_054919_Photos.webp
    Screenshot_20261108_054919_Photos.webp
    214.8 KB · Views: 11
Not to hijack but I have the same issue on my chipper and truck combo. So if anyone has the adjustable chute for a 2016 Bandit 1390 XP (probably works across several models) lemme know! Last I checked a couple of years ago, it was $2500 for the unpainted part from Bandit. Probably $3500 now, the way things are going.
 

New threads New posts

Back
Top Bottom