Today....

[davidwyby]

View this content on Instagram

View this content on Instagram

 

[27RMT0N]

Ha, never seen that technique before! I don't know anything about palms, but seemed well controlled. Do they hinge and stay attached at the base for a while folding like that?

 

[davidwyby]

Ha, never seen that technique before! I don't know anything about palms, but seemed well controlled. Do they hinge and stay attached at the base for a while folding like that?

I just pulled it out of my rear…a little sketch. Too big of a tree or wrong angle I think it might tip the lift back? Maybe… 5,000lb ish tree 26,000 lb machine, but leverage.

They hinge better than the eucalyptus I’m used to but not as good as a green conifer. Huge gap face and high back cut so it wouldn’t slide back. I did two. The one on the left I didn’t video, it was tight between spigot and the outbuilding.

 

[davidwyby]

pretty miserable dusty cutting the spurs off. Chain choking fibers, nasty dust. Taking the trees out with any other method I can thing of would be lots of miserable hand work.

 

[Matias]

Tree house minus dead trunk.
View attachment 101030


2-by floor will get patched.

View attachment 101031

Mt. Rainier

View attachment 101032


120' PSP took a handful of BigShot attempts. I was away from the collar with lots of backups and a Yates Screamer in my base-tie. I Wraptored up after bounce-testing and pruned of the conflicting branch that fought movement back toward the collar with ground manipulation of the rope.

View attachment 101033



View attachment 101034



Mt Rainier and Puget Sound
View attachment 101035



Tuesday's 125' pull down. I used a leather cambium saver. Alternatively, I might get a new ring and ring for knot blocking... long pulls can take a lot of force.
View attachment 101036

That's an awfully nice branch at 120'. I can't see the top; how much was left?

 

[Matias]

View this content on Instagram

View this content on Instagram

That was pretty slick.

 

[Treezybreez]

View this content on Instagram

View this content on Instagram

That was a confident performance. Well played, I can imagine you saved a lot of time lowering it that way.

 

[Treezybreez]

I estimate that this Water Oak weighed around 33,000 lbs.

 

[davidwyby]

That was a confident performance. Well played, I can imagine you saved a lot of time lowering it that way

The only other way I can imagine doing it would be to slash everything off from a bucket and chunk it down. The fronds are a nightmare. It would take several times longer, with two people instead of one.