Today....

After ages in the stock single-bridge config, I've finally decided to try dual-bridges on my MB 2.0. Not for redundancy but to run two different climb-systems together. I use the saddle almost entirely for spur work (I use a TreeMotion s.Light for pruning/actual climbing) and have set one a bit shorter and one a bit longer. On this saddle I mostly expect to use this setup to run a DRT line off one bridge, and my grapple on the other bridge, to move horizontally between tall firs. It will take a while before I have enough situations running it to know how I like it.

I also swapped the Notch Swinger saw-holder I've been using recently for a Shembeiner XLS, and today was the first use of it. I plan to make a thread discussing various saw-holders in the near future, as I've used a number of different systems over the last few years and have some thoughts. Honestly I love the Notch Swinger 80% of the time and hate it 20% of the time, which is enough for me to basically toss it in the 'bin of shame' in my shop and forget about it. Initial results with the Shembiner XLS are extremely promising. Prior to this most recent experimenting, I've used and enjoyed the transPorter for many years, and you can see one on my non-dominant side of the saddle as an accessory holder. Obviously this is all based on personal preference.

0 shem 01.jpg

0 shem 02.jpg

30 shem 02.jpg
 
Poor chickens
Yes they had to stay in the barn until we got it squared away. Luckily no chickens were injured when the tree fell! They were all in the blue hen house sleeping but I be they were scared chickenshit when that thing went over!
Did you get some eggs out of that one?
With the cost of eggs they weren’t parting!!
Looks like you were cooped up all day. ;)
Nope 2 hours show up to fold up! Oonly cause I wasn’t too chicken to buy that crane!
 
Thanks, fir snags always look a ton better when you can keep a few stubbed off limbs, and carve up the limbs just like the top so they aren't straight cuts. Also of course they provide actual perching spots for certain birds.

Most of the time I make/leave snags, the first limbs don't start until well above the safe height to leave them at so it's just a vertical pole at the end, or they are so small it just looks dumb. The structure of the tree lead to better than normal results in terms of the final look.
 

New threads New posts

Kask Stihl NORTHEASTERN Arborists Wesspur TreeStuff.com Teufelberger Westminster X-Rigging Teufelberger
Back
Top Bottom