Outlaw saws

Hence why all my climbing saws are modded. Timing advance and gutted muffler.

Sent from my SM-N970F using Tapatalk
Wouldn’t have saved in this scenario, was cutting twisted palms. There was no point on the diameter of the trunk that the kerf didn’t squeeze tight after being cut. Because had been grown in too close proximity to other palms...
 
I avoid palms as much as possible but when I have done them as removals I push the bar in and out of the kerf multiple times. It gets more and more of the fibers that just seperate but then closed back on the bar first pass through.
 
I avoid palms as much as possible but when I have done them as removals I push the bar in and out of the kerf multiple times. It gets more and more of the fibers that just seperate but then closed back on the bar first pass through.
It’s a good technique, these ones though I walked around with the tip only multiple times and the crush continued. Only thing that may have worked would have been a 460 with a super short bar - something I will be arranging for future...
 

New threads New posts

Back
Top Bottom