MS201T After Repair

[Steve Connally]

Hey guys. I have a 201T that the inside of the carb was caked with tiny saw dust. The had to take the plate off the carb and clean the screens next to the high and low intake lines. Anyway. It has been modded bu the guy in indiana about 2 years ago. Now that its all back together from the shop it doesn't scream like it did with the ecm and all the other stuff he either removed or disconnected. Anybody have a fix I can do to get that idle up with full throttle. I tried to adjust the high fuel mix screw. No luck

 

[Steve Connally]

It's a Snelling Mod

 

[Steve Connally]

Bumping the post. I'm thinking maybe the tech reconnected the ECM or something like that. Does anybody know how to adjust the high end besides on the outer handle housing. That does nothing.

 

[bushwackertree]

Not sure whats up with your saw but try getting a hold of Brad Snelling thats probably your best bet, not sure if he's a member here but I know he's a member over at AS. He'd be the guy to point you in the right direction.

Best of luck
Ben

 

[Steve Connally]

Are you on as? If so would you be willing to give him my email?

 

[bushwackertree]

Sorry Steve I'm not on as anymore and I've googled on how to get a hold of him with no luck other than through as. Maybe someone on here goes over there.

Ben

 

[Steve Connally]

Thanks anyway.

 

[Steve Connally]

Just put ANOTHER carb on the 201. Have no idea what went wrong with the old carb. Second carb in 2 years.

 

[craneguy1]

Damn ethanol.