NWPEZ's latest activity
-
NWPEZ replied to the thread Lanyard Positioner?.Looks like desicion has been made but I run an og swivel zig zag. F ing epic work positioning, tending,second tie in point, etc. Have... -
Tuebor hooked us up with saddle and helmet. The boy is stoked and is checking the front steps every 30 min even though labor day weekend...
-
NWPEZ replied to the thread ISO kids harness.I have twin 4 yr old boys. I got the petzl oiustiti or something like that spelling. Ha. When they were 3 and it works great. Was a...
-
A method for testing low resistances like big wires is to load them with current and measure the resultant mV drops along its length...
-
NWPEZ replied to the thread Dump bed issues.If you have any recommendation of companies for motor or entire unit be stoked to hear. Sounds like you’ve been down this road a few times.
-
Also, don't think that you are coming across as inept. There's a difference between ignorance and ineptitude, ignorance can be fixed...
-
NWPEZ replied to the thread Dump bed issues.Copy that. Thank you very much for the response. I assume by the bed build and welds the whole pump unit isn’t very quality. I’ll look...
-
NWPEZ replied to the thread Dump bed issues.Wiring is correct size but it is possible that there could be corrosion somewhere. I’ll do my best to trace lines. I don’t think my...
-
If your wire size is correct, that's a pretty considerable voltage drop. It seems like your motor is pulling too much current, which...
-
NWPEZ replied to the thread Dump bed issues.Yes 10 volts at pump under load. So I’d be looking at a new lift motor if that’s the case?
-
I’ve got a 2011 ram 5500 with a third party dump bed installed when I bought it roughly 6 yrs ago. It’s always been super strong until...
