Saw Modz

[Fabz]

 

[Fabz]

I rest my case ... in all fairness this is a non-mtronic saw and the Snailerizer may have come up with better-porting since the video was shot ...

 

[treegongfu]

I have an echo cs-400 that takes stihl PM3 chain. Does anybody know of I can convert an echo cs-490 to run the same chain? Is there a sprocket that will fit the 490?

 

[Fabz]

Why not run Stihl Picco on both saws ?

 

[treegongfu]

It calls for different chain. I think I need to change the sprocket. ?

 

[Fabz]

Try Baileys ; if not danzco might have ... I would make the switch to the ps63 picco chain ... FAST cutter !

 

[treegongfu]

Thanks Fabz. I will have to look into it.

 

[Fabz]

Thanks Fabz. I will have to look into it.

Yeah ... you shud be able to convert both saws over to it ... if u run it sqr/sqr grind you will pick up quite a bit of speed with the chain alone

 

[Fabz]

I can make loops for ya if u decide to go that route ... it's ps63(yellow chain)