bobcat starts but will not move?

[jeff74]

Hey guys any help would be great! I have a t190 bobcat, it will start, run a few seconds then a light and beeping start....after about 5-10 seconds of that it shuts off. It will start back up right away only to do the same thing again??? The light looks to be low hydro fluid. I get it to read error code and it says none???
HELP! thx!

 

[jeff74]

And yeah, I put hydro fluid in it. Still same thing??

 

[twigg]

check oil sounds like a safety shut off switch that automatically shuts it down if oil pressure gets too low or engine runs hot. doesnt sound like it runs long enough to run hot so could be oil pressure too low. sometimes those murphy switches go bad or the oil sending unit has gone bad and is causing it to read too low of pressure

 

[Gorman]

try posting on the heavy equipment forum under the skid steer thread. People on there really know their stuff.