200t rpm

bull is that with a muffler mod? i'm at 15895. i think it needs to have the high needle turned out some
 
iv'e got the high needle turned as far as it will let me go stock and i'm still pulling 15500. should i take the restricters of the adjustment screw and take it down to 14500? it is 23 degrees far. outside.
 
so i took the restricter of the high end screw and wow what a difference. i got 14500 and it feels like it has ultra power
 
Without muff mod, 14-14.5. With muff mod, could be anywhere from 14-15.5. You have to find that sweet spot in the cut. this may require you to remove the limiter caps on the H and L jets. Always get the saw hot before tuning, then tune with a tach to close to what it should be. then put the saw into a log and turn the H screw each way 1/8 turn at a time till you find the sweet spot in the powerband.
 
You must log in or register to reply here.

New threads New posts

Back
Top Bottom