192t problem

[RexMan]

I have a 192t that is almost 3 years old. Yesterday I did my monthly cleaning on it, and it just won't start. I cleaned the carb, Checked the spark, used another plug (just in case) and checked the flywheel gap (.012). The plugs are getting drenched w/ fuel. It seems to be flooding out after 2 pulls with or without choke on. Figured i'd post here before I took it in to my dealer. So if anyone has any input it would be appriciated.

 

[Treetrim]

Open up the carb and see if your needle is stuck open.

I had a different saw that had worn ring around the needle seat and would start but flooded also.

Sounds like a easy trouble shoot.

 

[BostonBull]

Is the venturi stuck closed?

 

[Rookieclimber]

I had a problem same as you, i did some tweaking with the idle and low rpm screws for the fuel. fixed it fine just takes some tinkering

 

[RexMan]

Well I figured it out... The Cast key on the flywheel was broken, my fault of course. I replaced the clutch and in doing so sheared the key off. Caused it to go out of time. $83.00 for a new flywheel and I'm back in business. Thanks for all the replies.

 

[Deak]

always keep an eye on the flashback screen on the exhaust of the muffler. running cheep mix will clog that up real fast.