Recent content by mcordani

  1. M

    026 hard starting and bogs down while cutting

    I'm pretty much 100% sure I put the parts all in correct. I think I just flooded it bad as I am not used to it getting gas since it was so gummed up. Is TA the idle adjustment? I've never touched the H, but refactoried the L at one turn out. It was set at two turns out which probably...
  2. M

    026 hard starting and bogs down while cutting

    OK, I rebuilt the carb and the screen in it had a thick layer of gunk in it. With everything rebuilt and clean I went to start the saw and I think it badly flooded. Fuel actually came out of the compression release. After that I took the plug out and drained fuel from the cylinder. I then...
  3. M

    026 hard starting and bogs down while cutting

    So weird as I bought my saw new and it doesn't have a spark arrestor. I know because I tried to clean it. I'll have to check the air filter to see if it is set wrong. I don't remember if mine has that adjustment. I'll definitely get a new fuel filter as mine hasn't been replaced. My fuel is...
  4. M

    026 hard starting and bogs down while cutting

    Hello, I am new here and hope you can help out. I have an Stihl 026 pro that is about 8 years old that has been more and more of a pain to start. Once it starts I can warm it up but then it is tempormental. Sometimes as I cut it bogs down and I have to back off to get it to rev back up again...
See more

New threads New posts

Back
Top Bottom