Bucknut
Carpal tunnel level member
Hi all. Just wondering if most of you hang large saws from caritools. I'm using the Edge saddle (Ergo Lite), and it has a caritool slot on each side for hanging a saw. Problem is, I have a little issue with hanging an $800 saw from a $7 piece of unrated plastic. So I have been using a Kong HMS instead. But I miss the caritool's flat back and retainer clip! The Kong swivels back and forth as I remove and replace the saw. Also, the Kong tends to snag the saw lanyard- it's not ideal. I've looked at alternatives like the ISC Paddle but it doesn't have a flat back either.
So...... What do you guys use? And how sweet would a rated (aluminum) caritool be? I should note that I'm a little old school in that I just use a short lanyard for my saws- no use of the attachment point on the back of the saddle. Seems to get in the way.
Also, can't emphasize enough how much I've learned from this forum. I've been climbing for a long time, but have consistently been impressed by the innovations and techniques seen here. Thanks in advance to all.
So...... What do you guys use? And how sweet would a rated (aluminum) caritool be? I should note that I'm a little old school in that I just use a short lanyard for my saws- no use of the attachment point on the back of the saddle. Seems to get in the way.
Also, can't emphasize enough how much I've learned from this forum. I've been climbing for a long time, but have consistently been impressed by the innovations and techniques seen here. Thanks in advance to all.