Looking for Foot ascender on climbing spurs.

[MikePowers321]

actually the buckingham hole spacing is closer than Klein now that I think about it.

I made more rights

 

[Jimmycrackcorn]

actually the buckingham hole spacing is closer than Klein now that I think about it.

I made more rights

Interesting...

So why do you think they are blowing them out over at TS?
Do you think they are trying to come up with something in house for the new Jetstep?

 

[Stihl4life]

actually the buckingham hole spacing is closer than Klein now that I think about it.

I made more rights

Mike i recieved my powercender for my kleins today. I also ordered the the HASS connection for kleins for under $3. Not sure what that is for. Can you fill me in?

 

[MikePowers321]

The Haas connection will go on the opposing spur. You can face it forwards or backwards. If your Haas/Saka does not have a built in footloop, but rather uses a carabiner that hooks into a seperate footloop, you can clip in and use the connection point in a rope walking system with your spurs. If you do this, just make sure to use some sort of gaff protection because it can feel a little clumbsy, but does works well

 

[Jehinten]

I also purchased one of these recently since I'm running kleins and the price was too good to pass up. I'm a little concerned on the fit though. Is this normal?

The plate for the ascender is flat while the shank is curved. I haven't fully tightened it yet, and I think if I do it will bend the aluminum plate to match the profile of the spurs. Go ahead and crank it down, or is something not quite right?

 

[Stihl4life]

I tightened mine down and it moulded perfectly to the shaft.

 

[MikePowers321]

Tighten screws. Itll mold

 

[Jehinten]

Read directions

Thanks. I did look over them the other day when it came in. Just now installing them today and had forgotten or skimmed over the moulding part.