Search results

  1. L

    90xp

    Looking at a 2012 90xp with a Perkins with 925 hours . I spun the disc around it seemed smooth but it almost stoped but went backwards and stopped could it be out of balance ? Any more info would be appreciated
    • Lbj
    • Thread
    • 150xp 90xp balance bandit buying chipper disc
    • Replies: 5
    • Forum: General Discussion
  2. L

    Sold

    Okay , thanks for the info
  3. L

    Sold

    Thanks for the fast reply , looking at a similar Truck same tool boxes but only a 8 feet bed was still curious What size bed you had and did hold a good bit of chips , thanks
  4. L

    Sold

    What is dimensions of the bed ?
  5. L

    bandit chipper disc bearings

    had a friend help me since he has a nice shop and tools . he mostly used the torch and then cut the inner race so far with a cutting wheel then a cold chisel
  6. L

    bandit chipper disc bearings

    Thanks for all the replies, the manual recommend ep-2 grease , any one recommend a brand
  7. L

    bandit chipper disc bearings

    OkAy , thanks
  8. L

    bandit chipper disc bearings

    Thanks for the info , did pull the whole disc and both bearings are bad
  9. L

    bandit chipper disc bearings

    No set screw
  10. L

    bandit chipper disc bearings

    does this pull out in one piece , or does the ring around the shaft need to be removed first if so does it turn / screw out . thanks for your help
  11. L

    New Gas Chippers how are they?

    was wondering the size of that chip box ? I am small and have a bandit 90xp and looking at a nice f350 dump 4x4 , with xpac tool boxes behind cab , but only a 8 ft bed , I guess can always make it a little bit taller chip box
  12. L

    Bandit 65 - Replacing Engine

    Also where did you get the exhaust and motor
  13. L

    Bandit 65 - Replacing Engine

    Thank you for the info
  14. L

    Bandit 65 - Replacing Engine

    I picked up a 2003 bandit 65aw for $300.00 in pieces , needs a motor , I am going to replace a old Honda 20hp with vanguard 35hp but all the mufflers are on the back of the motor , guess I need a side mount ? Also where can find a wiring diagram for the chipper Thanks for any help

New threads New posts

Kask Stihl NORTHEASTERN Arborists Wesspur TreeStuff.com Teufelberger Westminster X-Rigging Teufelberger
Back
Top Bottom