moss's latest activity

  • moss
    moss replied to the thread Bulldog Lynx.
    If you get to the point of putting it into production please let me know, thank you. -AJ
  • moss
    moss reacted to surveyor's post in the thread Bulldog Lynx with Like Like.
    Ok, so the 9mm holds just under 400 lbs. on a single line, and the 8mm holds just over 200 lbs. on a single line.
  • moss
    moss reacted to surveyor's post in the thread Bulldog Lynx with Like Like.
    In the picture, I have pulled down hard of the Lynx so it takes a sort of "set". When fully loaded the upper arm extends upwards and...
  • moss
    moss reacted to surveyor's post in the thread Bulldog Lynx with Love Love.
    By adding 1 link, the Lynx is now able to be used on this 8mm or 9mm line.
  • moss
    moss reacted to Jehinten's post in the thread Knee ascender attachment with Like Like.
    I run my knee ascender on my left leg, bungee goes through the left lower dee and clipped to the right lower dee. This gives the bungee...
  • moss
    moss reacted to surveyor's post in the thread Bulldog Lynx with Like Like.
    So here is an improvement to the Lynx. I replaced the rubber nubs with a machine screw and friction nut, so that the friction at the top...
  • moss
    moss reacted to surveyor's post in the thread Bulldog Lynx with Like Like.
    The 9mm I have is stiff to tend, until it is flattened a bit by the Lynx, I would say it is not quite as grippy as the beeline, but...
  • moss
    moss replied to the thread Bulldog Lynx.
    Thx for the clarifications. Beeline is tough but it is a relatively soft cordage. It needs to be soft enough (small bend radius) to...
  • moss
    moss reacted to surveyor's post in the thread Bulldog Lynx with Like Like.
    11.7 is too fat for the lynx, however I did make a device 10+ years ago using the next size larger link, which was essentially a ZZ with...
  • moss
    moss replied to the thread Bulldog Lynx.
    It's designed for SRT 10mm lanyard and/or Captain Hook line as I understand it. Bulldog Bone is the bee's knees for Yale 11.7mm...
  • moss
    moss replied to the thread Bulldog Lynx.
    Looks like a winner!
  • moss
    moss reacted to surveyor's post in the thread Bulldog Lynx with Like Like.
    These size 60 ss links lend themselves to the 10mm beeline. The top rope wrench style link is 30 thousands narrower gap than than the...
  • moss
    moss reacted to RyanCafferky's post in the thread pre-emptive WTB Buck Throttle with Haha Haha.
    I’ll give you $300 since Matias is a cheapskate.
  • moss
    moss replied to the thread Bulldog Lynx.
    Yes! The quest continues, thx Gordon -AJ
  • moss
    moss reacted to southsoundtree's post in the thread Bulldog Lynx with Like Like.
    INTERESTING
Show older items

New threads New posts

Back
Top Bottom