Shop, garage, parking, etc.

That’s about how the permitting process is here too, upwards or beyond 12 months!

Ouch. The worst part is that the county was so bad at all of this, everyone was suing them, and eventually just building multi-million dollar homes on the waterfront without permits because the government basically wasn't functioning. At one point the entire department got fired, now they are outsourcing all permit reviews to some outside contractor to 'speed things up'. Well it's certainly not faster, and now just some third party black-box with no way to communicate with....
 
Building a pole barn that you plan on insulating and finishing sucks, very time consuming and lot's of added costs you wouldn't think of. If I had to do it again, the same size, I'd do a frost wall, slab, then build with 2x6 studs on top of that.

On that note, yah I've been going through a similar process. I was originally going to build a pole barn and then finish the inside, but now am going with a slab and traditionally framed 2x6 walls. In the end I'll wind up with a much better building.
 
Ouch. The worst part is that the county was so bad at all of this, everyone was suing them, and eventually just building multi-million dollar homes on the waterfront without permits because the government basically wasn't functioning. At one point the entire department got fired, now they are outsourcing all permit reviews to some outside contractor to 'speed things up'. Well it's certainly not faster, and now just some third party black-box with no way to communicate with....
Here the county is under the microscope of Department of ecology, something extreme like 90% of all bulkheads installed since 2016 were unpermitted.
That and our 200’ shoreline code is so atrocious it talks about the ‘National Arborist Association’ tree care standards.
 
How much does a stump grinder permit cost? How quickly do those happen?

I can see the purpose of protecting clean water. 1000' feet is pretty far though...100' seems reasonable. Even better, base it on a formula of distance and slope. When all the trees go, water gets dirty pretty quickly. We almost never see a clear river around here being about 70% agriculture and 40% of that ranked as "intensive till"...only 15% using cover crops. When there is bad flooding people think the solution was to get rid of trees along the river.

So, while I'm not a big fan of government permits for everything, sometimes I can see the purpose. Hopefully they don't make it too burdensome and not a money grab - just barely enough to cover the cost of administration.
 
How much does a stump grinder permit cost? How quickly do those happen?

I can see the purpose of protecting clean water. 1000' feet is pretty far though...100' seems reasonable. Even better, base it on a formula of distance and slope. When all the trees go, water gets dirty pretty quickly. We almost never see a clear river around here being about 70% agriculture and 40% of that ranked as "intensive till"...only 15% using cover crops. When there is bad flooding people think the solution was to get rid of trees along the river.

So, while I'm not a big fan of government permits for everything, sometimes I can see the purpose. Hopefully they don't make it too burdensome and not a money grab - just barely enough to cover the cost of administration.
They've been nasty down there for the last couple months. When I went through toledo yesterday there wasn't anyone in the river fishing lol, it was really cranking and really stained :baba:.
I go to your meijer at least once a month, I think I'll be there tomorrow. Everyone needs flowers and plants...
 
Yeah the Maumee has been running high. Bad for fishing but probably great for the Walleye population.

You Grand Rapids OH or MI? Assuming OH...MI is a long way to come to the Findlay Meijer for plants! Ever get over to North Branch Nursery? Or Leonard's in North Baltimore is great for flowers. I'm not above buying plants at Meijer if they have what I'm looking for...but the others usually have better selection. But not everything... client wanted a specific hydrangea I could not find anywhere so having Home Depot ship them to me.
 
Yeah the Maumee has been running high. Bad for fishing but probably great for the Walleye population.

You Grand Rapids OH or MI? Assuming OH...MI is a long way to come to the Findlay Meijer for plants! Ever get over to North Branch Nursery? Or Leonard's in North Baltimore is great for flowers. I'm not above buying plants at Meijer if they have what I'm looking for...but the others usually have better selection. But not everything... client wanted a specific hydrangea I could not find anywhere so having Home Depot ship them to me.
You're correct, walleye should be really good in the lake this yr. It's been a while since I've done that, the water was above the docks in MI when I went back then.
MI, I typically run to all the meijer stores on the north, east, and south side of Columbus twice a week delivering flowers and plants, mostly for indoor sales(we have other drivers that deliver carts to lawn and garden.
Never been to any of those, but have been to some near defiance/Bryan/west unity as I have relatives I've helped with landscaping there, I also have a niece up the rd from you in bowling green(Ohio, not KY lol, but I've been there plenty too).
We also do quite a bit of the product at home depot as well, but I don't push loaded carts, so I only pick up empties there on a rare occasion.
 
Island life makes logistics a bit 'extra' and I have things spread across three properties on two islands and take ferry between them. I'm sure many of you have seen my photos of that whole thing...

I live on a very large piece of property (don't own it) where I have space for anything I'd want equipment-wise, but I make a point of not bringing materials there. I've got use of a small shop space there and covered space. It's were my primary truck is that I daily drive and keep tools in, as well as my secondary chip truck and secondary chipper, since just a fraction of my work takes place on the island I live on.

On the other island, I sometimes keep my primary chipper and primary chip truck at a friends property because they are very close to the ferry landing and it makes my logistics easier, but I also own 5 acres where I park equipment and have a small shop trailer. That is where I'm working on building a 50x60 4-bay shop with an apartment that will be the foundation of my business for... the rest of my life, and my small home till I can afford to build the final house. I'm working with my builder right now on the design, and it's going to be a long and expensive process. Been taking about it for years, lots happened in between, but I think it's finally happening this year....ish. Permit guy told me they are currently at about 6-10 months to even review and approve permits....

View attachment 98559

View attachment 98560

View attachment 98561

View attachment 98562
my county dicked me around for almost a year too. sounds like par for the course.
 
Last edited:
How much does a stump grinder permit cost? How quickly do those happen?

I can see the purpose of protecting clean water. 1000' feet is pretty far though...100' seems reasonable. Even better, base it on a formula of distance and slope. When all the trees go, water gets dirty pretty quickly. We almost never see a clear river around here being about 70% agriculture and 40% of that ranked as "intensive till"...only 15% using cover crops. When there is bad flooding people think the solution was to get rid of trees along the river.

So, while I'm not a big fan of government permits for everything, sometimes I can see the purpose. Hopefully they don't make it too burdensome and not a money grab - just barely enough to cover the cost of administration.
I sold my stump grinder last year and I am better off for it. I have found two guys that are cheap so they can deal with all that nonsense. But 1000’ is damn near every customer I’ve ever had. The farm runoff is by far more of an issue than a 20” stump grind 900’ from a lake IMO.
 
I sold my stump grinder last year and I am better off for it. I have found two guys that are cheap so they can deal with all that nonsense. But 1000’ is damn near every customer I’ve ever had. The farm runoff is by far more of an issue than a 20” stump grind 900’ from a lake IMO.
No doubt! On both accounts:
If you have a reliable stump grinder let the handle it.
And farm runoff and road construction (really about any construction) are going to add much more sediment than grinding stumps - especially if grindings are left there - probably less runoff than before it was ground!
 
I'm on a 5.5 acre ''farmstead'' in a very rural area.
Works for me. Plenty of room to grow and expand, if I ever do. Would like to purchase the 66acres sold off, before me, and add back to this parcel.

Levi, do what's comfortable for you. Take on more if you choose to. If it seem expensive, you will adjust to the increased overhead....and get it done.
Remember, the deeper you dive in, the less time to yourself until everything adjusts.
Sometimes, staying small is comforting. I should push myself to grow, but I'm a bit to comfy now. I need to get of my ass and push myself.

Which is exactly my aim after this Sun morning 2nd cup of joe. Get my ass of this couch and shit done around here. LOL
 

New threads New posts

Kask Stihl NORTHEASTERN Arborists Wesspur TreeStuff.com Teufelberger Westminster X-Rigging Teufelberger
Back
Top Bottom