Hey, I found my 10mm!

On the flip side of the coin, does this topic bring back a recollection of some time where you were so exasperated working on something, lost a tool, nut or bolt and just said eff it I ain't digging in there to retrieve it?
 
What about pressure circumstances like get the engine swap fully buttoned up before the snow storm hits? I find I just get slower and slower the more tired I get, mentally confirming I'm not pulling an omission or bonehead move.
 
On the flip side of the coin, does this topic bring back a recollection of some time where you were so exasperated working on something, lost a tool, nut or bolt and just said eff it I ain't digging in there to retrieve it?
I was working on the mini, the high flow lever lost its pin so I pulled the top cover off new pin installed. Then putting the top cover back on I dropped one of the bolts and it fell under the engine. It had a good life up top now it rides in the belly of the beast never to see daylight again.
 

New threads New posts

Back
Top Bottom