- Location
- Retired in Minneapolis
Found! One 10mm socket
- Thread starter Tom Dunlap
- Start date
Matias
Been here much more than a while
- Location
- Butte County
Of all sizes, why would you burn the 10mm?!?
- Location
- Retired in Minneapolis
Matias
Been here much more than a while
- Location
- Butte County
Your knee is replaceable. Shit, the whole oil pan is replaceable. Everything is replaceable, but the 10mm is one of the most used sizes. Like, why not use the 11mm?
Shadowscape
Been here a while
- Location
- far north
If it didn't hang down where it is going to hit stuff, it is not all that bad of an idea.
I tried one of those quick drain valve oil plugs once on my rig. Took me about a week before I sheared it off on a rock and lost all my oil. I was fortunate enough to have saved the orig. oil plug and had it and five gallons of oil on the truck. The pain was trying to remove the broken off threaded part of the valve that was still in the oil pan. But in an hour and a half I was operating once again.
I tried one of those quick drain valve oil plugs once on my rig. Took me about a week before I sheared it off on a rock and lost all my oil. I was fortunate enough to have saved the orig. oil plug and had it and five gallons of oil on the truck. The pain was trying to remove the broken off threaded part of the valve that was still in the oil pan. But in an hour and a half I was operating once again.
- Location
- Retired in Minneapolis
Did you open the A'zon link? LOL
Matias
Been here much more than a while
- Location
- Butte County
I hadn't. Thanks for insisting.
Lignotuber
Participating member
- Location
- Socal
I was thinking more like why a 1/4". Probably regret not going 3/8 lol
Matias
Been here much more than a while
- Location
- Butte County
They're gonna use an impact driver anyway
New threads New posts
-
test
-
-
KBNest -Midline Attachable SRS Canopy Anchor.
- Started by TreeSteward
- Replies: 1
-
-
-
-
