August Hunicke Videos

August Hunicke said:
In this case, the high point was way forward and would have instantly let so much slack into the speed line that I got a greater advantage by keeping the line tight at the height that it was. In other words, it would have snagged much worse as it dropped hard down the backside of the tree into the hedge.
Click to expand...
it's not a specific criticism of your job August, just the principle of the technique is what I'm pointing out. Let's say, a higher point then, not the high point that as you say was much further forward than what appears in the video. Most of your speed line Vids show something similar ie you cutting through 5 or 6 multislung branches in rapid succession, bang, bang, bang....great video clip when you have a steep line angle and airspace, but I was simply making a point to the previous poster, or others who might not be familiar with zip lines that it can also counter productive for some trees and situations. A second line/control line is another good addition to using the direct highpoint, if you need to raise stuff before letting it run. Easy enough for the climber to manage also. When you showcase a technique on a tree forum it's always worth elaborating on the pros and cons.
 
Yep, Yep, I'm trackin' with you on all counts. It was actually seeming 50-50 at the time. My thoughts were, Should I capitalize on that high anchor or should I anchor the limb to itself to keep the line tight. I chose the method that made me have to add a sling and take longer than just cutting it off with one sling on it, LOL and, I was actually talking to Joe about it in the headset.

The limb right previous to that one, I got the advantage of slipping through the hedge by tip tying and being butt heavy to keep all the Velcro up higher.
 
No worries.

This is not for your benefit August, but just to get a visual to others who might not picture what we're describing.

Here you see utilizing a direct high point; mid tie slinging; a climber operated control line; and a dynamic far out ground anchor....that being a big strong guy pulling like crazy when I tell him. The objective being to swing the limbs from the back of the tree out to the landing. Use HD setting

 
Reg said:
A downside with redirects or setting multiple slings at once is right there at 2:30. Had the line been going direct to the highpoint rather than the next intended limb, it wouldve been much easier to free the snagged/stalled branch just by pulling the line, which would raise it considerably. Same principle goes for swinging/raising limbs from the back of the tree out to the front, as the highpoint creates an MA of sorts and the ability to create lift. As it was set, the best that could be done was just bounce the line or slack it off to free such a stuck branch in the vid. Not a big deal for Augusts pine tree here, but something to consider went setting setting multislings nonetheless. Always great vid and work August, I'll pass on the bling though.
Click to expand...

I understand what you're saying. The situation I've seen where Augusts technique would work is when I've set the zip line and there's that one branch that just a little too far below the line. If you were to just clip the strap on the line you'd have too much slack. When the branch comes off there'd be a big drop before the weight of the branch is caught on the line. Augusts technique looks like it could save you some time, albeit a few minutes, but still a timesaver nonetheless . Unless I'm completely misunderstanding what's going on here.
 
GreenMntnBoy410 said:
I understand what you're saying. The situation I've seen where Augusts technique would work is when I've set the zip line and there's that one branch that just a little too far below the line. If you were to just clip the strap on the line you'd have too much slack. When the branch comes off there'd be a big drop before the weight of the branch is caught on the line. Augusts technique looks like it could save you some time, albeit a few minutes, but still a timesaver nonetheless . Unless I'm completely misunderstanding what's going on here.
Click to expand...
That's why I did it but it's up for debate which would've been better in this case.
 
GreenMntnBoy410 said:
The situation I've seen where Augusts technique would work is when I've set the zip line and there's that one branch that just a little too far below the line.
Click to expand...
That's what I'm talking about with adding an adjustable speed line sling or two into the mix for the odd ball limbs . More so for crowned out hardwoods than straight up and down conifers.
 
GreenMntnBoy410 said:
I understand what you're saying. The situation I've seen where Augusts technique would work is when I've set the zip line and there's that one branch that just a little too far below the line. If you were to just clip the strap on the line you'd have too much slack. When the branch comes off there'd be a big drop before the weight of the branch is caught on the line. Augusts technique looks like it could save you some time, albeit a few minutes, but still a timesaver nonetheless . Unless I'm completely misunderstanding what's going on here.
Click to expand...

Its all good mate. Theres lots of tricks to be had with all those slings at hand. Many people wrongly assume that the sole purpose of zipline rigging is to save dragging brush....when in reality it can be so much faster and less labor intensive than conventional rigging with the right situation and strategy.
 
Whoa...that was a rush! Thanks for putting so much into these videos. My wife is always wanting to know when you've put one up so we can watch it together.
 
I really enjoyed that. Thanks so much. I don't know too much about Jerry. I have only read one of his books but will likely pick up the others now. I found that very interesting.
 
Fantastic job August!! Very respectful and informative interview! Can't wait for part 2.
 
You must log in or register to reply here.

New threads New posts

Kask Stihl NORTHEASTERN Arborists Wesspur TreeStuff.com Teufelberger Westminster X-Rigging Teufelberger
Back
Top Bottom