Protos sena install
- Thread starter Yimboob
- Start date
deevo
Been here a while
- Location
- Horseshoe Valley, Ontario, Canada
I've done 3 I'll dig up some pics for you and pm you
monkeylove
Been here much more than a while
- Location
- Roslyn, Pa.
There are some around. I just did mine a few months ago, super easy.
deevo
Been here a while
- Location
- Horseshoe Valley, Ontario, Canada
I sent him some of my most recent install, should suffice I hope !
Sent from my iPhone using Tapatalk
monkeylove
Been here much more than a while
- Location
- Roslyn, Pa.
I did mine right after the expo. Steve was showing how simple and straight forward the install was.
Thanks guys i did it a ghetto way but got it going. Didnt have a drill bit so used a small saw file to make a hole between the soft part of muffs and plastic piece. Did a sound test on one before i did the other and sounds the same. Thanks for all the help ajd pms guys
Sent from my SM-G935P using Tapatalk
Sent from my SM-G935P using Tapatalk
Richard Mumford-yoyoman
Been here a while
- Location
- Atlanta GA
Can you say Velcro.
- Location
- Corvallis, Oregon
Are you installing the smh10r ? That is what i am thinking about getting and installing as well. I would also like to see how its done. What are the benefits of doing it yourself vs treestuff installation. And do you buy directly from sena or try to save money by searching around?
monkeylove
Been here much more than a while
- Location
- Roslyn, Pa.
Velcro
I just have the smh10. I already had it but got a protos. I ghetto rigged the ear muffs and didnt cut through the earmuffs. I used a small saw file on the top of muffs to make enough room for a chord. Since the muffs go over it and its sticky its worked very well and never lost any ear protection. The ear protection was what i was worried about by putting holes into the actual plastic. Thats how ill install my next one (hopefully 10r cause i bet itd fit on inside of helmey with my being able to push buttons.
Sent from my SM-G935P using Tapatalk
Sent from my SM-G935P using Tapatalk
monkeylove
Been here much more than a while
- Location
- Roslyn, Pa.
I used my pocket knife on mine instead of a drill. What ever works, I ain't rocket science.
- Location
- Raymond, NH
installing on the protos is pretty straight forward. I also used a small file to allow the wires to go into the muff with out pinching the wire. Over time my right wire chaffed and is in and out with a connection. Next time I'd add some protection there. Good luck!
