Chipper knive bolts

[evo]

Just because I am lazy and don't really have much trust in our local hardware stores (really crappy bottom shelf stuff). I'm hoping to find a good source for knife bolts, even if I have to buy a few boxes of them.
If relevant this is for a 12xpc which I'm told has the same drum as a 12xp.

 

[VenasNursery]

Acme nut and bolt
South West Detroit
(313) 842-7044

Far from you but good prices bad shipping prices

 

[Serf Life]

Modern group is fine, also use Northeastern arborist suppy https://northeastern-arborist-supply-633503.shoplightspeed.com/search/Bandit+bolts/

 

[CTtreeNWC]

Modern group is fine, also use Northeastern arborist suppy https://northeastern-arborist-supply-633503.shoplightspeed.com/search/Bandit+bolts/

Did you see the Accusharp Knife sharpener they have in the Chipper Parts section? I can only assume its possible for us to sharpen our own knives with a regular looking kitchen knife sharpener?! Northeastern seems pretty good if you have a Bandit, Im looking for Morbark Bolts

 

[Tom Dunlap]

Most medium sized cities are large enough to support a fastener supplier.

Fastenal has been mentioned in the past. The chipper builders don't make the fasteners so there are no 'Bandit' or'Morbark' bolts.

 

[flushcut]

Fastenal, Grainger, McMasterCarr.

 

[Vicente]

The bolts aren't so bad, I've got a disc chipper though and over 5$ a nut is rough.

 

[evo]

Thanks for the reply, and yes I will look at the manual but I assume they are grade 8?

 

[Reach]

Thanks for the reply, and yes I will look at the manual but I assume they are grade 8?

On a Bandit, yes, they are Grade 8 bolts. Probably 5/8”, and 2” or 2 1/2” long, but check your manual to be certain.

 

[Simpleiowaguy]

I use Mcmaster Carr for almost all hardware. I live in a small rural town though.

 

[southsoundtree]

Did you see the Accusharp Knife sharpener they have in the Chipper Parts section? I can only assume its possible for us to sharpen our own knives with a regular looking kitchen knife sharpener?! Northeastern seems pretty good if you have a Bandit, Im looking for Morbark Bolts

Touch-ups.

 

[Fivepoints]

As others have said, McMaster Carr is a good source. Our 990xp takes 5/8 x 2.0 bolts. Use good grade 8.